Welcome to the CAN-bus Wiki project

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

controllers:atmel [2014/10/11 23:38]
heinz [32 bit Controllers]
controllers:atmel [2018/08/21 23:09]
Line 1: Line 1:
-====== Atmel ====== 
- 
-Try to put the latest devices on top of each section and mark end-of-line products. Only specify the main parameters of the micro controllers and go more into deep with details about the CAN interface. Always try to put a link to the data sheet or manual. 
- 
-===== 8 bit Controllers ===== 
- 
-===== 16 bit Controllers ===== 
- 
-===== 32 bit Controllers ===== 
- 
-  * [[http://www.atmel.com/products/microcontrollers/arm/sam3a.aspx | SAM3A]] ARM Cortex-M3 micro-controllers with two CAN channels, Ethernet and USB. [[http://www.atmel.com/Images/doc11057.pdf | SAM3X/SAM3A Series Complete]] PDF manual. 
- 
-  * [[http://www.atmel.com/products/microcontrollers/ARM/SAM4E.aspx | SAM4E]] ARM Cortex-M4 micro-controllers @ 120Mhz with two CAN channels, Ethernet and USB, two independent 16-bit ADC. Interesting is an offer for the  free download of the "Studio 6 IDP" (integrated development platform). ATSAM4E-EK evaluation kit. [[http://www.atmel.com/Images/Atmel_11157_32-bit-Cortex-M4-Microcontroller_SAM4E_Datasheet.pdf | SAM4E Series Complete]] PDF manual. 
-  * [[ http://www.atmel.com/products/microcontrollers/arm/sama5d3.aspx| SAMA5D3]] ARM Cortex-A5 microprocessor @536 MHz 850-DMIPS.  Two CAN on-chip modules. Atmel Linux distributions at [[http://linux4sam.com| linux4sam.com]] 
-  * [[http://www.atmel.com/devices/sam9263.aspx?tab=overview | AT91SAM9263]] ARM926-based microprocessor running @240MHz. Networking peripherals include USB host and device interfaces, a 10/100 Ethernet MAC and one CAN channel. There are also four USARTs, two SPIs, CompactFlash, SD/SDIO/MMC interface and a TWI. The controller runs Linux. 
-  * Cortex-M7-based MCU [[http://atmelcorporation.wordpress.com/2014/10/02/atmel-samples-new-family-of-atmel-smart-arm-cortex-m7-based-mcus/ | announcement ]] October 2014, the part should have 2 CAN FD channels :-) :-) 
-===== DSPs ===== 
- 
-===== Stand alone CAN Controllers ===== 
  

QR Code
QR Code controllers:atmel (generated for current page)