Welcome to the CAN-bus Wiki project

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
controllers:atmel [2014/10/13 16:46]
heinz [32 bit Controllers] SAMA5D4
controllers:atmel [2018/08/21 23:09] (current)
Line 1: Line 1:
 ====== Atmel ====== ====== Atmel ======
 +[[http://www.atmel.com/| ATMEL]]
 +
 + --- // 2015/12/22 16:15// rumour that ATMEL will be sold, [[http://www.dialog-semiconductor.com/ | Dialog Semiconductor]] or [[http://www.microchip.com | Microchip]] 
 +
  
 Try to put the latest devices on top of each section and mark end-of-line products. Only specify the main parameters of the micro controllers and go more into deep with details about the CAN interface. Always try to put a link to the data sheet or manual. Try to put the latest devices on top of each section and mark end-of-line products. Only specify the main parameters of the micro controllers and go more into deep with details about the CAN interface. Always try to put a link to the data sheet or manual.
  
 ===== 8 bit Controllers ===== ===== 8 bit Controllers =====
 +High-performance, Low-power AVR® 8-bit Microcontroller family
  
 +[[http://www.atmel.com/Images/7682S.pdf | AT90CAN32/64/128]]
 +  * 15 Full Message Objects with separate Identifier Tags and Masks
 +  * Transmit, Receive, Automatic Reply and Frame Buffer Receive Modes
 +  * 1Mbits/s Maximum Transfer Rate at 8 MHz
 +  * Time stamping, TTC & Listening Mode (Spying or Autobaud)
 +
 +[[http://www.atmel.com/Images/Atmel-7647s-Automotive-Microcontrollers-ATmega16M1-32M1-64M1-32C1-64C1_Datasheet.pdf |   ATmega16/32/64/M1/C1]] 
 +  * Full CAN controller
 +  * 6 Full Message Objects with their own separate Identifier Tags and Masks
 +  * Tx, Rx, frame buffer or automatic reply configuration
 +  * Time stamping
 +  * 1Mbit/s maximum transfer rate at 8MHz
 +  * TTC timer
 +  * Listening mode (for spying or autobaud)
 ===== 16 bit Controllers ===== ===== 16 bit Controllers =====
  
 ===== 32 bit Controllers ===== ===== 32 bit Controllers =====
- +  * [[http://www.atmel.com/products/microcontrollers/arm/sama5.aspx#SAMA5D2_series SAMA5D2]] ARM Cortex-A5 SoC @500MHz down to 166MHz,extended -40 to 105°C, two CAN FD [[controllers:c_can|BOSCH M_CAN]] :-), USB HSIC support, ARM NEON™, floating point, free Linux distribution available at [[http://www.at91.com/linux4sam/bin/view/Linux4SAM/Sama5d2XplainedMainPage | Linux4sam.com]], 
-  * [[http://www.atmel.com/products/microcontrollers/arm/sam3a.aspx | SAM3A]] ARM Cortex-M3 micro-controllers with two CAN channelsEthernet and USB[[http://www.atmel.com/Images/doc11057.pdf | SAM3X/SAM3A Series Complete]] PDF manual. +  * [[ http://www.atmel.com/devices/ATSAMA5D41.aspx |SAMA5D4]] ARM Cortex-A5 microprocessor @528 MHzARM NEON™ SIMD engine for accelerated signal processing**No** CAN.
- +
-  * [[http://www.atmel.com/products/microcontrollers/ARM/SAM4E.aspx | SAM4E]] ARM Cortex-M4 micro-controllers 120Mhz with two CAN channelsEthernet and USB, two independent 16-bit ADC. Interesting is an offer for the  free download of the "Studio 6 IDP" (integrated development platform)ATSAM4E-EK evaluation kit. [[http://www.atmel.com/Images/Atmel_11157_32-bit-Cortex-M4-Microcontroller_SAM4E_Datasheet.pdf | SAM4E Series Complete]] PDF manual.+
   * [[ http://www.atmel.com/products/microcontrollers/arm/sama5d3.aspx| SAMA5D3]] ARM Cortex-A5 microprocessor @536 MHz 850-DMIPS.  Two CAN on-chip modules. Atmel Linux distributions at [[http://linux4sam.com| linux4sam.com]]   * [[ http://www.atmel.com/products/microcontrollers/arm/sama5d3.aspx| SAMA5D3]] ARM Cortex-A5 microprocessor @536 MHz 850-DMIPS.  Two CAN on-chip modules. Atmel Linux distributions at [[http://linux4sam.com| linux4sam.com]]
-  * [[ http://www.atmel.com/devices/ATSAMA5D41.aspx |SAMA5D4]] ARM Cortex-A5 microprocessor @528 MHzARM NEON™ SIMD engine for accelerated signal processing**No** CAN.  +  * [[http://www.atmel.com/products/microcontrollers/ARM/SAM4E.aspx | SAM4E]] ARM Cortex-M4 micro-controllers 120Mhz with two CAN channelsEthernet and USB, two independent 16-bit ADC. Interesting is an offer for the  free download of the "Studio 6 IDP" (integrated development platform)ATSAM4E-EK evaluation kit. [[http://www.atmel.com/Images/Atmel_11157_32-bit-Cortex-M4-Microcontroller_SAM4E_Datasheet.pdf | SAM4E Series Complete]] PDF manual
-  * [[http://www.atmel.com/devices/sam9263.aspx?tab=overview AT91SAM9263]] ARM926-based microprocessor running @240MHz. Networking peripherals include USB host and device interfacesa 10/100 Ethernet MAC and one CAN channelThere are also four USARTs, two SPIs, CompactFlash, SD/SDIO/MMC interface and a TWIThe controller runs Linux.+  * [[http://www.atmel.com/products/microcontrollers/arm/sam3a.aspx | SAM3A]] ARM Cortex-M3 micro-controllers with two CAN channels, Ethernet and USB[[http://www.atmel.com/Images/doc11057.pdf | SAM3X/SAM3A Series Complete]] PDF manual.
   * Cortex-M7-based MCU [[http://atmelcorporation.wordpress.com/2014/10/02/atmel-samples-new-family-of-atmel-smart-arm-cortex-m7-based-mcus/ | announcement ]] October 2014, the part should have 2 CAN FD channels :-) :-)   * Cortex-M7-based MCU [[http://atmelcorporation.wordpress.com/2014/10/02/atmel-samples-new-family-of-atmel-smart-arm-cortex-m7-based-mcus/ | announcement ]] October 2014, the part should have 2 CAN FD channels :-) :-)
 +    * [[http://www.atmel.com/products/microcontrollers/arm/sam-v-mcus.aspx| SAM-V70]] Cortex-M7 @300MHz, up to 1 MiB FLASH and 384 KiB Multiport SRAM, two CAN FD,
 +    * [[ http://www.atmel.com/products/microcontrollers/arm/sam-e.aspx| SAM E70]] Cortex-M7 @300-MHz, up to 2 MiB FLASH, Ethernet with MI/RMII, USB High Speed with on-chip PHY, dual BOSCH CAN FD
 +      * CAN FD with up to 64 Data Bytes Supported
 +      * BOSCH MCAN implementation
 +      * Up to 64 Dedicated Receive Buffers
 +      * Up to 32 Dedicated Transmit Buffers
 +    * e.g. [[http://www.atmel.com/Images/Atmel-11296-32-bit-Cortex-M7-Microcontroller-SAM-E70_Datasheet.pdf| E70 data sheet]].1782 pages,  chapter 45. //Controller Area Network (M_CAN)//
 +  * Cortex-M7 family,  SAM E70, SAM S70, SAM V71 and SAM V71. The SAM E70 series adds a 10/100 Ethernet MAC and dual CAN-FD :-) interface. The SAM V70 and V71 series support Ethernet AVB and Media LB.
 +    * [[http://www.atmel.com/products/microcontrollers/arm/sam-s.aspx| SMART SAM S]] Series
 +    * [[http://www.atmel.com/products/microcontrollers/arm/sam-e.aspx | SMART SAM E]] Series 
 +    * [[http://www.atmel.com/products/automotive/automotive_microcontrollers/smart-arm-based-automotive-mcus.aspx | SMART SAM V]] Series:
 +  * [[http://www.atmel.com/devices/sam9263.aspx?tab=overview | AT91SAM9263]] ARM926-based microprocessor running @240MHz. Networking peripherals include USB host and device interfaces, a 10/100 Ethernet MAC and one CAN channel. There are also four USARTs, two SPIs, CompactFlash, SD/SDIO/MMC interface and a TWI. The controller runs Linux.
 +
 ===== DSPs ===== ===== DSPs =====
  
 ===== Stand alone CAN Controllers ===== ===== Stand alone CAN Controllers =====
  

QR Code
QR Code controllers:atmel (generated for current page)