| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision |
| can_interfaces:main [2016/11/19 17:39] – [PCI Interfaces] heinz | can_interfaces:main [2016/11/19 17:40] – [PCI Interfaces] heinz |
|---|
| * [[http://www.janz.de | Janz]] - CAN/CANopen Interfaces for PCI based systems with up to 4 channels; | * [[http://www.janz.de | Janz]] - CAN/CANopen Interfaces for PCI based systems with up to 4 channels; |
| * CAN-PCIH 4 channels with IBM PowerPC? 405 | * CAN-PCIH 4 channels with IBM PowerPC? 405 |
| * [[https://www.janztec.com/en/products/boards/cancanopen/can-pcil/ | CAN-PCIL]] non intelligent board, up to 2 interfaces with SJA1000 CAN controller, On-board line termination 120 Ω ; enabled by jumper or software, 2 x diagnostic LEDs (green/yellow) per interface | * [[https://www.janztec.com/en/products/boards/cancanopen/can-pcil/ | CAN-PCIL]] non intelligent board, up to 2 interfaces with SJA1000 CAN controller, On-board line termination 120 Ω ; enabled by jumper or software, 2 x diagnostic LEDs (green/yellow) per interface, [[drivers:main|can4linux]] available |
| * [[https://www.janztec.com/produkte/baugruppen/can-fd/can-pcihfd/ | CAN-PCIH/FD]] FPGA based (Xilinx Zynq XC7Z015, 400 MHz), Up to 4 CAN-FD channels, Bus termination onboard (120 Ohm, software controlled), Data transfer rate up to 4 MBit/s :-) | * [[https://www.janztec.com/produkte/baugruppen/can-fd/can-pcihfd/ | CAN-PCIH/FD]] FPGA based (Xilinx Zynq XC7Z015, 400 MHz), Up to 4 CAN-FD channels, Bus termination onboard (120 Ohm, software controlled), Data transfer rate up to 4 MBit/s :-) |
| * [[http://www.kvaser.com | Kvaser]] - Kvaser PCIcanxII, Kvaser PCIcanx | * [[http://www.kvaser.com | Kvaser]] - Kvaser PCIcanxII, Kvaser PCIcanx |
